Shrek Planter

thingiverse

I added a hole for a potted plant and a smaller drainage hole down the center of each planter. I printed one at 197.97% scale for the green version, which perfectly fits a succulent planter three point five inches in diameter, and fifty percent scale for the blue one - it was a quick test print. My print settings were a bit off and I was using old filament, so it didn't print the best. At 197.97% scale, it fits a succulent planter three point five inches in diameter (eight point eight nine cm) perfectly. The smaller one I printed at point two millimeters with ten percent infill in blue inland pla, and that turned out pretty perfectly with no supports... The larger one I rushed with five percent infill and it got a little messy. Like an onion, my ogre has very visible layers. I put ogre ears on mine. Enjoy!