Shower shelf

thingiverse

My husband thinks this tiny shower shelf that fits into a corner is great because it holds his razor stuff. He can optionally print the small hook underneath that holds one of those Venus razors by itself and attach it to the shelf later with some glue. I have one in each of our bathrooms too. The decorative pattern on the front is actually engraved into the surface of the shelf. My husband fills it with a little bit of bathroom tile grout so it matches the color of the shower perfectly and makes cleaning much easier than having multiple filigree parts to assemble. Print Settings Rafts: Whatever rafts work for your setup Supports: Same here Post-Printing If you want to add the little hook underneath, my husband suggests printing both the shelf with a hole for the attachment and the small hook too. Then, simply use ABS pipe cement or an acrylic adhesive if you're using PLA, to attach the hook to the shelf by spreading a thin layer onto each and pressing them together firmly. As he mentioned, we fill the embossed design on top of the shelf with bathroom tile grout too! We just mix up about one teaspoon of any colour matching the tiles in the shower, and gently press it into the design with a wet cloth afterwards. Now my husband recommends gluing this tiny corner shelf firmly into place in your shower with some clear silicone sealant, similar to what he used for bonding glass. Just stick some masking tape underneath from below so it's held firm until set after 12 hours or so, then pull the tape off once its done and all is secure.