Shower head support

cults3d

I am happy to share with you this new creation, a shower head support! It will allow you to hang your shower head on the wall using a suction cup, but also using a pivot system, to adjust the inclination of the latter with a simple push of the hand, to satisfy both young and old... This support is printed in pla, in spite of its bad reputation on its resistance to humidity and heat, after a 3 months return, it still doesn't weaken... So you are free to choose the material for this support. On the other hand, you will need tpu, to guarantee the proper functioning of the pivot, which works on the principle of "skid", which exerts a sufficient force on the pivot by crushing (produced by a screw-nut system), so that it does not turn under the weight of the knob. (You will judge for yourself the tightening torque required for this). You will also need 6 self-tapping screws ST 3.5 from 13 to 6 mm threaded over the whole length, and a screw M3x20(min) and two nuts M3 (to make a nut and a lock nut for tightening) Finally, you will need a suction cup with a diameter of 57mm at max. crushing, and a height at crushing of 16mm min.