Shower head

thingiverse

Bathroom shower head with small water jets features more than 100 jets that gently hit your body. To achieve optimal results, print this design using 120% flow and a minimum of 20% infill, knowing that 100% is the ultimate goal. After printing, use a thin sharp needle to carefully open clogged holes by inserting it into each hole once only. The diameter of the needle will determine your water flow, combined with the pressure in your inflow pipe. If you appreciate this shower head design, be sure to check out my other creation on Thingiverse: http://www.thingiverse.com/thing:1859044 Print Settings: Printer: Wanhao duplicator i3 Rafts: No Supports: No Resolution: 0.25mm Infill: 20%-100% Notes: Make sure that holes in the first layer are partially clogged by overflow plastic, or you may need too much water to operate it effectively.