Shower Drain Cover

thingiverse

Manufacturing a replacement shower drain cover made from high-quality ABS plastic is a relatively straightforward process that requires some basic tools and materials. First, gather all necessary components including the new ABS plastic sheet, drill bits, screwdriver, hot glue gun, and a sharp utility knife. Next, carefully cut out the new drain cover to match the original dimensions using the utility knife or a craft knife. This will ensure a precise fit with minimal adjustments needed later on. Once cut, remove any excess material from the edges of the new drain cover using the drill bit or sandpaper to smooth them out completely. With all edges smoothed out, use hot glue to attach the ABS plastic sheet to the underside of the shower floor covering the entire area where the old drain was located. Make sure it is securely attached by applying even pressure with your hands until the glue sets firmly in place. After allowing sufficient time for the glue to dry completely, inspect the new drain cover closely to ensure there are no air bubbles or imperfections that could affect its performance over time. Finally, test the new drain cover under running water to verify it is functioning properly and not leaking anywhere along its edges. If any issues arise during this process, simply reapply more hot glue as needed until everything works seamlessly together once again.