Shot Glass Mould

thingiverse

I've managed to come up with something that's still rough around the edges but gets the job done. Check out the two files - when you print them, they'll turn into a two-piece mold for a shot glass. The originals had to go since there was no little alignment post attaching it to the mold, and taking it apart wasn't working out so well. To use this design, just stack the two parts together and fill it up to the line with Jell-O mix, water or chocolate - be careful when pulling them apart because if you're not careful, they might break. And if you decide to go with chocolate, wait until it's cooled down a bit because hot plastic can't mix with melted chocolate. So far so good, but feel free to share your thoughts on how I could make this better!