Shorty Center Console for NB Miata

prusaprinters

<p>Shorty center console to cover up the gaping hole left behind when removing the stock transmission tunnel cover, as well as cover the lower shifter boot.</p><p>This design allows you to use your stock NB Miata shifter boot and shifter boot retainer. You'll probably need to open up the screw holes on your boot retainer, but nothing that would prevent you from going back to stock. This attaches to the center stack using the stock screws from the original piece.</p><p>The STL files allow you to either print the group as one large print, or, if printing on a smaller print bed, in two halves to be epoxied together later.</p><p>This print is intended to retain full reversibility; no permanent modification to the car or surroundings are required.</p><p>PRINTING TIPS:</p><p>HIGHLY HIGHLY recommend printing this upside down. If printed "right side up", the supports will be nearly impossible to remove without damaging/destroying the boot retainer screw pegs.</p><p>For printing in one piece, have at it. I don't have experience with this printed whole, but I don't imagine it would be a problem. Just print upside down and with your favorite supports and temperatures.</p><p>I don't have a printer large enough to do this in one piece, so I've included STL's to print in two pieces:<br>Print the "front" with the cut side down, using tree support. Use whatever bed adhesion you need to get it to stick. If my Ender 3 can print this one, yours can too.<br>Print the rear upside down, with the boot retainer screws facing the sky. Use whatever supports you like best; I used tree supports.</p>