Shining Winter Star

prusaprinters

+++ Winter Star +++ What do you need except the print files:glue to assemble the star parts [Tri & Quad] “I used UHU for plastic parts”E14 ribbon cable with a switch and a lenght of 5 meter or longer to reach a power socketthe light bulb socket must be dismantledE14 LED bulb 4W or 6Wthe right distance of the light bulb socket that the light source is placed concentric: “Star Cable Holder” 80/90/100 mm !!!Caution!!!                                                                                                                                                     Disassembling of the light bulb socket only without electricity and at your own risk! !Advises!The 3 frame parts can be stack together without any glue.The “Star Cable Holder” you don't have to glue! You have to stack it together. I have done it in the last step. But before stacking it together you need to disassemble the E14 socket and seperate the cables out to mount the holder between the switch and the light bulb socket! Don't forget to remove the supports of the little round clips!With supportsRemoved supportsNow you can stack it together.Beware that it is very difficult to disassemble this part “Star Cable Holder” without destroying it if you have glued all other pieces to the frame!  **Print Instructions** *Middle Frame and Top/Bottom FrameSupports: YesResolution: 0.2mm Infill: 15%                                                                                                                                                   Pattern: rectlinear or cubic                                                                                                                     Brim: No*Tri StarSupports: NoResolution: 0.2mm (I used variable layer hight for a little part of the top)Infill: doesn't matter                                                                                                                                 Brim: Yes                                                                                                                                            Vase Mode is possible but takes more time…*Quad StarSupports: NoResolution: 0.2mm (I used variable layer hight for a little part of the top)Infill: doesn't matter                                                                                                                                 Brim: YesVase Mode is possible but takes more time…*Star Cable HolderSupports: Yes [paint-on supports the overhang of the clips an use the “Style: Snug” in options]Resolution: 0.2mm Infill 1: 15% [Main Body]                                                                                                                       Infill 2: 100% [The whole clips with modifier]                                                                                       Brim: YesI recommend you to use the print files, that i uploaded!I used PLA for the showen prints.