Shielded mount for 'Daylight' LED stick for Voron0.1+

thingiverse

I improved a ‘Voron 0.2 shielded LED bar for Daylight on a matchstick v2.1 by RZT’ by C0co_838112 https://www.printables.com/model/469315-voron-02-shielded-led-bar-for-daylight-on-a-matchs This is a remix of a version that can be printed on Voron0 bed (you will need to rotate the model by 45dgr) Original Daylight LED Stick: https://github.com/VoronDesign/Voron-Hardware/tree/master/Daylight Version on my photos is with additional switch in the middle. Bought from Aliexpress --- My version is: - using less filament (walls are thinner and with more consistent thickness) - holding 1515 extrusion better - using less space (it's closer to side panels than to print space) - diffusing the light (optional) - lights more space of lower printer parts (optional) - using more common M3x8 screws instead of M3x12 - with a bigger hole for a switch part (in the middle) - with much smaller files Aditionally I made an extender for a switch (may need of glueing; I just heated it up and pushed it in and it is holding for now) It is now easier to turn it on/off/half Bracket clip (LEDshield_BRACKET_NEW) is made on base of my Cable clips for 1515 extrusion https://www.thingiverse.com/thing:5323119 --- Files list (see render): 1. LEDshield-angled 2. LEDshield-angled-diffused - recommended 3. LEDshield_rmx - this is the closest to original design by C0co_838112 4. LEDshield-diffused 5. LEDshield_SWITCH - used to extend the switch 6. LEDshield_BRACKET_NEW - print 2 for each LED stick, use with M3x8 screws You can use just a brackets if you don't need a shielded case Just add washers and M3 nuts on the other side to hold the LED stick --- Printed with ABS and Transparent PET-g (4 first layers of 0.2mm of ‘diffused’ version) 2-3 walls no infill needed no supports needed I cutted holes in the back panel for cables (you can see it on one photo) I connected the wires directly to PSU, in the place where my 24V to 5V adapter is connected --- Update 07 VIII 2023 New diffused version with 0.8mm of diffusser instead of 0.4mm You can lower the model by 0.4mm if you want less diffused light ---