Sherline Lathe Tool Holder Stand

thingiverse

Sherline Lathe Tool Holder Stand. I created this to securely hold standard Sherline tool holders; typically, I keep the cutters in place since they've been precisely adjusted for center alignment and so forth. Three cavities per unit were all that was needed, after which I printed multiple units for my own use to efficiently organize my rapidly expanding collection of cutters. The hole at the bottom serves as a designated spot for the T-nut located on the block's underside, providing it with a fixed position. Finished measurements reveal a stand that is 2 inches (50mm) deep and 5 inches (125mm) wide and 0.7 inches (18mm) tall; I always have to adjust my STL files in Slic3r due to this precise measurement. Print the part with holes on the bottom, just as shown in the accompanying photo.