Shendrones Thicc Removable Leg Mount

thingiverse

Removable leg mount for the Shendrones Thicc fpv cinelifter, to open up the bottom plate and give more room for mounting multiple batteries, as well as quick and easy leg removal for transport and storage. Designed for 12mm OD carbon tube legs, which can be cut to any length you need. There is clearance for up to 8" props. This mount is designed to be installed between the arms and bottom plate, essentially using the bottom plate as a large washer to distribute the clamping force. M3 screws are used both for the main mounting holes, and to clamp the legs in the print. There are 2 files for left/right. You will need to print 2 of each. Screws installed up from the bottom so that there are no sharp ends sticking down to poke batteries. Quick note on installation: When installing the mount between the arms and bottom plate, the 2 screw holes furthest from the leg line up fine with the frame, but the one closest to the leg is off slightly and you may need to wind that screw in by hand to get it started, but it is not off enough to affect anything functionally. I will update the STL's when I get a chance. PLA, printed 0.2mm with solid infill. No supports needed. NOTE: PLA is more brittle than the original TPU legs. They have held up fine in MY testing during normal use (gentle and controlled landings). I claim no responsibility or liability for damage caused to your aircraft or payload etc. if the prints fail for any reason. Please do your own testing and use at your own risk. Happy flying :)