Shendrones Shrieker XT30 mount

thingiverse

Update: Redid the entire design from scratch. The updated version now positions itself squarely at the back, ensuring power wires are not entangled with props when using taller motors (1306 or 1407). This configuration also allows you to securely attach a 4-LED WS2812 square using sticky tape. A built-in brim on the spacer enhances adhesion. For better wire management, a simple mount for an XT30 connector is included, keeping battery wires out of propellers. To assemble, slide the spacer onto the base first, followed by the mount on top. Use a file to gradually reduce the spacer's size until it perfectly fills the gap between the upper and lower plates. If necessary, drill a 5mm hole through the post to accommodate the connector. The XT30 connector should easily fit into place with minimal force applied. Test fit is recommended before adding a small amount of superglue to all sides for added security. Print Settings: Printer: Mendel90 Rafts: Not Required Supports: None Resolution: 0.2mm