ShenDrones 5" Mako LED Mount

thingiverse

Human: Mounts an Adafruit NeoPixel Stick to the back of the Mako, angled at approximately 45° to match the forward flying angle, and includes a small retainer for holding the power cable below towards the battery. Print Settings Printer Brand: Printrbot Printer: Printrbot Plus Rafts: No Supports: Yes Resolution: 0.2mm Infill: 20% Notes: TPU is preferred for this print. The flat bottom should be placed on the print bed, and minimal support should be used to ensure clean prints of the pins. Post-Printing CA is used to secure the LED strip to the mount. Hot glue proved ineffective due to the smooth surface of the LED strip, making it difficult to hold securely.