Shelly Qubino Wave (1 & 2PM) 90° DIN Mount

thingiverse

I made this starting from another similar model, to leave some room for the external antenna of the new generation of shelly devices (the qubino/wave ones, using z-wave protocol), which wouldn't fit in the original model.I originally tried drilling a hole in the original model, but fitting the device without tilting wasn't possible (I finished breaking the print in the attempt), so I took the path of modifying it.I made a hole around where the antenna comes out of the device, and also carved some space so that it's possible to slide the unit into the print vertically without damaging the antenna.If it breaks another time, I'm considering enlarging a bit along the direction of shelly's terminal block so that it's fit but not pushing too much the unit (at the moment it look a bit too small, if I look at the unit after mounting it, from the terminal block, the right side of the print is somewhat bending outwards..)Hope this will be handy to someone else :-)