ShellStrike DS-6 Spring Spacer and Reinforcements

prusaprinters

<ul> <li>Spring Spacer for the Nerf ShellStrike DS-6 Blaster</li> </ul> <p>prints in two halves so you can install them into the plunger head without removing the plunger rod. (see photo, yellow spacer)</p> <p>In theory, there is still more room for spring compression; but I didn't want to risk it. The DS-6 has a weak plunger rod. If you want to experiment with z-scaling the spacer; in theory it could be up to 12mm tall. (current file is 8mm)</p> <p>-DANGER: the DS-6 blaster has a weak plunger rod; people have already broken theirs by using Upgraded Springs.</p> <p>a Spacer is by no means as strong as an Upgrade Spring, but the risk is still there.</p> <ul> <li>Spring Stop Plate Reinforcement</li> </ul> <p>This plate reinforces the thin internal shell wall that the spring rests against.</p> <ul> <li>Priming Reinforcement</li> </ul> <p>These small tabs insert into the priming handle to (theoretically) increase the surface area that engages the priming rod; to reduce the odds of breaking it.</p> <p>(epoxy recommended)</p> Category: Toys & Games