ShelfSys - 3d printed joints for DIY furniture

thingiverse

I design a versatile shelving system for my kitchen, but its potential goes beyond that. The entire project relies on just three distinct 3D printed components and six millimeter screws. The frame is built using a sturdy one-inch thick pine sheet, carefully cut into strips of the same width. Meanwhile, the shelves themselves are fifteen millimeters thick. To bring this design to life, I used the following settings for my 3D prints: Resolution: A precise .2 millimeters Infill: The highest level of density at 100% Raft and Supports: Yes, with a strategic angle of 45 degrees