Shelf with no groove for horizontal printing

thingiverse

The original files were set up for vertical printing. The thin parts of the diamonds weren't printing well for me, so I modified the files to be able to print flat on the bed by removing the overhangs that would require support. As a result, this doesn't have the groove for the miniature racks, but I imagine they will slide in and out just fine. I also planed off the bottom because there would have been another overhang. I notched out the middle support slot to remove an overhang as well. You should be able to glue a peg there still. Finally, I filled in the strange peg hole in the middle of the thin diamond. I can't fit both halves on my ender 3 pro now, but printing them flat will save me about 5 hours and some filament. Additionally, printing them horizontally is more structurally sound. There are still the overhangs where the riser pegs go, but they should print fine without support. The overhangs were removed by eyeballing and subtracting/adding shapes, so the middle peg slots probably won't be the exact same and I imagine the miniature racks will have a bit more clearance.