Shelf Support Peg

prusaprinters

<p>The shelf support pegs in my bathroom vanity were always falling out, so I modelled and printed some that would fit a little tighter. They seem to be working so far.</p> <p>The peg has a diameter of 5mm</p> <p>The platform that holds the shelf was around 2mm thick on the original clip. In my design, I beefed it up to 3mm. I've included the STL that I used and a thin one that sticks to the original 2mm thickness.</p> <h3>Print instructions</h3><p><strong>Supports:</strong> No</p> <p><strong>Resolution:</strong> 0.1 mm</p> <p><strong>Notes:</strong></p> <p>Print the flat side down. Use a brim if you find that the end of the peg is warping</p>