Shelf Peg - 4mm diameter

thingiverse

Rushed to build this shelf peg because one was nowhere to be found! Prints perfectly, no issues at all. Side-printing recommended, use Cura with full support and solidify completely in just 30 minutes flat. Orient properly and print it sideways - works beautifully. To do this right, import the object into your Cura software - you'll need to turn it 90 degrees so it prints from the side, like normal furniture pegs do. Be sure to set those support structures for printing in that orientation - it makes all the difference! Set the infill at full strength and get ready to watch it spring to life on its own terms. Print time is a snappy half an hour.