Shelf Leveler Maxit

thingiverse

Bought a MaxIt™ 35-1/2"W x 56-1/4"H x 24"D 4-Tier Plastic Freestanding Shelving UnitModel Number: 91093MEN-C1-17 Menards ® SKU: 2113526 ????????The shelving bows and if you need a way to have a flat level surface, these pieces will do that with the addition of a piece of plywood to fit. All parts needed on one sheet. Print four times.Do NOT auto orientate the Block. Print the block with threaded area and hole up, square cutout down. I find it leaves a cleaner threaded hole and is easier to clean the support from the rectangle cutout side.Print with support, base only setting.35% infill.Slower speeds on outer walls for good thread build4 wall loops. Can be reduced4 top and bottom layers. Personally would keep for strength and not change.Support will twist off easily from the Vis. Clean support out of rectangular area of Block. Grease the threads lightly. Install Vis through the rectangle cutout side of Block so the tip just sticks out round hole side. Push on the Boule. Turn back the thread until Boule sits inside hole. Drop the block into an open outer side hole in the shelf. Push the Knob onto the bottom side of the Vis. Drop the Shelf Level into slots it will fit in. Do this for all four corners of where you will place a piece of wood you want leveled on the shelf.