Shelf display for 360 controller

cults3d

Recommendations: I would recommend 100% infill on the display for a solid grip on the shelf or table. A 10% infill and 2mm wall thickness is more than enough for the clamp screw. Don't change the angle of the models, they are placed that way to optimize the part strength. This model will need supports, just make sure the supports doesn't destroy the thread. A piece of electrical tape on the "ceiling" of the clamp will increase the grip. (see pictures) Don't tighten the clamp screw too much. It might crack the print and won't improve the grip, most likely the other way round. The clamp fits tables or sheves between 12.5 mm and 20 mm thick, I would not recommend to rescale the model. Nofify me if it's too big/small for your shelf and I might modify the model.