Shelf Bracket

thingiverse

I Designed some shelves for my office and printed really cool shelf brackets! The design is a 3" angle, meant for two screws into the shelf and one screw into the wall. You can use any board that's six inches deep or less. However, in the picture shown, the used board was five inches deep and 24 inches wide. If you need a strong shelf, depend on your wall anchors! It's recommended to drill into a stud or use a 50lb anchor for support. You'll need two prints per shelf, so I recommend using 25% density with three shells in three layers both at the top and bottom. This way, you can easily install your board using two screws on each bracket and one screw that includes an anchor to secure it to the wall!