Sheet music holder for drums

thingiverse

This is my sheet music holder for my electronic drum set. It clips on the horizontal beam. ## Construction - Put the printed screw into the holes on the stand and on the support piece. - If the hole is too rough for the screw to be inserted, you can use a piece of sandpaper wrapped around your drumstick handle to smooth it out. Rotate the sandpaper with the drumstick handle in the hole to create a smooth, even surface. The screw should slide in easily. - You can use a rubber mallet to hammer the screw gently through the holes. - Clip the opposite end of the support piece to the vertical beam of your drums. - Use two 40 mm M5 screws and a winged nut to secure the support piece to the vertical beam. - Tighten the winged nuts gently as not to deform the vertical beam of your drums. - Put the stand into the final position and use the printed nut to secure it.