She-Ra Horde Prime Mind Control Chip

thingiverse

---WARNING--- This print has sharp points! This should not be printed and given to kids without adult supervision. A less sharp version is also included, but still be careful! This is a cosplay mind control chip from She-Ra used by Horde Prime. When printed at 100% size the main chip is 45mm or about 1.77" (then the spikes extend from that). So you can do the math to adjust size to fit your neck size. I strongly suggest printing this at 0.1 or 0.15 layer heights AND using variable layer heights to pick up extra crispr curves. After printing the center piece will need some very minor sanding on the flat sides to make it fit cleanly in the main chip. Once assembled I then suggest you dip the piece in near boiling water to soften it and then mold it to the back of your neck (be careful not to burn yourself). The spines will mold easily after a short dunk in the water, but it will take a minute of soaking to be able to curve the main chip. It doesn’t take much, but the result is worth it. BE SURE to fit the center piece before molding as it will not fit afterwards. After molding, it can be further finished or painted as usual.