Shaving Brush Stand

prusaprinters

This shaving brush stand was designed to improve airflow and for the brush to hang dry. Standing the brush up on its handle causes the water and soap to drain into the handle of the brush. This is bad, as over time it will weaken the adhesive and cause the bristles to fall out prematurely. The solution to this problem is to allow the brush to hang dry. Hang drying allows the water/soap to drain downwards off the bristles of the brush, thus prolonging the life span of the brush.The stand is sturdy yet minimal in design. This was done to provide the brush with as much exposure to air as possible, thus improve dry times, which is good for the hygiene of your brush. Recommended Settings:Layer Height: 0.2mmPrint Orientation: leave as is in the .3mf file (with the back against the build plate)