Shark Vacuum Onboard Accessory Holder (ICZ362H)

prusaprinters

<p>Vacuum accessory holders to be mounted to the vacuum using 3M Command Strips or double sided tape. Though these should work with any 40mm diameter vacuum accessories, they were designed specifically for the Shark Vertex Pro Powered Lift Away vacuum (Model ICZ362H) as this model has a lot of detachable parts where other accessory holders might be in the way (probably why on-board storage wasn't included in the first place). The use of Command Strips allows the holders to be placed to avoid interference with Lift Away function, use of wand or stick vac modes, as well as dustbin, battery, and air filter removal.</p><p>There are two holders and two versions of each. Holder A has a small ledge on the bottom to prevent the crevice tool from sliding out of the holder. Holder B has no ledge as the other accessories have a small lip to prevent sliding. The long versions have an extended back plate to use a full size Command Strip for extra support, while the short versions have a shorter back plate for a smaller or trimmed down Command Strip.</p><p>Recommend printing in the vertical orientation to help avoid layer splits in the ring arms. No supports needed. I printed with PETG for a bit of extra strength and flexibility for long term use. Tested at 100% and 25% infill, and both worked fine. Could probably go a bit lower.</p><p>EDIT: Command strips turned out to be a bit of a pain when the accessories would bump into things during vacuuming and the whole clip assembly would pop off at the command strip. I opted to replace it with double sided mounting tape. Slightly more permanent, and when accessories bump into stuff, just the accessory pops out, so all you have to do it stick it back in the ring rather than line the command strip back up.</p><p><strong>TL;DR</strong> 40mm diameter vacuum cleaner accessory holders to be attached to the vacuum with double sided tape or similar. Short and long versions available. Print in vertical orientation. No special print settings.</p>