Shark Poker Card Capper

thingiverse

This is a weighted poker card capper. It is placed on your hole cards during a hand to make sure they are not accidentally folded. The base is designed with the same diameter (39mm) as a standard size poker chip so this will stack perfectly on your chips when not in use. This design features a great white shark leaping to attack a dollar symbol. If you like this, you may want to check out my collection of card cappers. To print this design: 1. Print one of each part. 2. The dollar sign does not need supports. 3. I printed the holder (upside down) and base with line support material spaced at 4.5mm. To assemble this design: 1. Place four nickels inside the holder as ballast before snapping it into place in the base. 2. Snap the base over the top of the holder, making sure the nickels are secure. 3. Apply glue to the bottom of the shark and push it onto the tab in the middle of the water. The fins on the shark should slide into the slots in the water, and the shark must face the correct direction. 4. Apply glue to the cylinder that sticks up from the dollar sign and underneath/behind the shark's upper teeth. Slide the dollar sign cylinder into the throat of the shark and use slight pressure to push the dollar sign under the shark's upper teeth. Enjoy your print, and if you do print one, please post a picture!