Shark Hose Tip

prusaprinters

<p>Bought a Shark Apex Duoclean Zero-M Upright and noticed that the hose-tip has rubber on it, presumably to better seal into the head. However, when you use the hose the massive suction combined with the rubber tip makes it drag hard against the floor. I'm concerned that the tip will wear over time and make an imperfect seal with the vacuum head.</p> <p>I made this so that the tip wont get worn, and it'll be easier to move around the edge of the floor without dragging or sticking.</p> <p>Updates:<br/> v3 - 5mm taller</p> <h3>Print instructions</h3><p>I added a .2mm first layer so that adhesion wont be a problem. Just break that out after you're done printing.</p>