Sharbot Ng, Spool support

thingiverse

Sharebot NG Spool Holder Mounting Instructions Mounting the spool holder on your Sharebot NG 3D printer is a straightforward process that requires minimal tools and expertise. Before starting, ensure you have all necessary components, including the spool holder, screws, and any additional accessories provided with your printer. Begin by locating the designated mounting points on the printer's frame. These are typically marked with small holes or tabs that indicate where to attach the spool holder. Remove any protective covering from these areas, as they may be coated with a thin layer of plastic or other materials to prevent scratching during shipping. Next, take the spool holder and align it with the mounting points on your printer's frame. Gently push the holder into place until you feel it click securely into position. Make sure not to force the holder, as this could damage either the holder or the printer's frame. Once the spool holder is in place, use the provided screws to secure it firmly to the printer's frame. Be sure to tighten these screws evenly and snugly to prevent any movement or wobbling of the holder during operation. With the spool holder mounted and secured, you can now load your filament onto the holder as instructed in your printer's user manual. This may involve threading the filament through a small opening on the holder or clipping it into place using a small clip provided with the holder. After loading the filament, ensure that it is seated properly and not twisted or kinked. A twisted or kinked filament can cause printing issues or even damage to your printer's extruder. Finally, double-check that all screws are tightened securely and that the spool holder is level and stable. Your Sharebot NG 3D printer is now ready for use with the new spool holder mounted and secured.