Shapton Kuromaku Stone Holders

thingiverse

These are 1, 2 and 3 stone holders or trays for Shapton Kuromaku (or Shapton Pro, I think) sharpening stones. They are sized to retain the stone, but still allow use of the full width of the stone, even with a jig. Additionally there are numbers that correspond to all of the grits currently offered by Shapton. These can be dropped onto the trays in your slicer to label which stone goes where. I *STRONGLY* recommend orienting the tray so that numbers are at the top, especially if you are using a sharpening jig. If they are at the bottom, you may not have reach when it comes to flattening the backs of chisels, plane irons, or other single bevel blades. Coordinates to place numbers are below. All references are from origin at center of each component, and in millimeters. *Three Stone Tray:* -113,97.25,15 -113,0,15 -113,-97.25,15 *Two Stone Tray:* -113,48.625,15 -113,-48.625,15 *One Stone Tray:* -113,0,15 If you want to change filament for the numbers, I found that to be at layer 75 on my slicer and settings, but it should be at 15mm height from the bed. I have also included Sketchup files in case you want to modify the items.