Shapeoko 2 Quiet Cut Spindle Speed Controller Housing

thingiverse

Housing for the Inventables Quiet Cut Spindle Upgrade is specifically designed for the variable speed controller, an essential component for Shapeoko2. \nImportant Details\nEach part in this housing has been engineered to snap seamlessly into place or onto the enclosure. As a result, only specific parts should be used to ensure optimal fitment.\nEssential Components:\nEnclosed Power Supply - 30353-03: This critical piece is available at https://www.inventables.com/technologies/enclosed-power-supply\nPower Entry Module - 30349-01: Locate it at https://www.inventables.com/technologies/power-entry-module\nSpindle Speed Controller (one size fits all): This component can be found at https://www.inventables.com/technologies/spindle-speed-controller#30417-01\n \n \n Installation Guidelines\nBuild your enclosure with the face facing downwards on the build plate. \nThe Power Entry Module slides smoothly into the square hole located in the right/front face of the housing. You may need to carefully file either the pocket edge or module tabs to ensure a snug fit.\nThe tab from the potentiometer in the Spindle Speed Controller neatly fits into the keyway of the round hole in the left/front face of the enclosure. \nSecurely finger-tighten the spacer and nut outside the enclosure before sliding the knob over the potentiometer shaft. The speed controller itself slides onto the top of the housing, nestled comfortably between its PCB and heatsink.\nOnce all wires are connected, the square tabs on the housing will snap perfectly into place within the outermost set of vertical cutouts in the power supply, situated above the terminal block.