Shapeoko 2 Arduino Mount

youmagine

To Assemble: Use 4 x 10mm M5 bolts and nuts to fasten the printed component firmly onto the end plate. Next, detach the Grbl shield from the Arduino if it's currently attached. Then, secure the Arduino to the printed part using 3 x 10mm M3 bolts. I chose not to use the fourth hole because my bolt caps were too large and would have obstructed the header pins on the Arduino. Reattach the Grbl shield afterwards. To ensure cable stability, thread a zip tie through the long hole in the bottom of the printed part and the end plate. Additionally, secure the power cable to the bottom of the end plate using a zip tie to relieve stress there as well.