Shaped dampers for the Anet A8 frame

thingiverse

These are dampers I designed to cut down on vibrations from the printer that get transferred to the table. On top of that, they're also meant to keep the frame rigid. Since they're made with TPU containing 20% filler material, it'll be possible to level out any uneven surfaces the printer is sitting on. I placed these dampers under the printer frame and then loosened the screws a bit to release any strain caused by their installation. After that, I tightened everything back up again. I suggest checking if inserting them creates an unbalanced motion between the front and rear of the frame. If you do experience this issue, like I did, just loosen the structure's screws a little to ease the tension and then tighten them up again.