Shampoo Bar Tray

prusaprinters

Recently, I switched over to using Shampoo Bars instead of liquid shampoo in an effort to cut down on waste (says the guy with the 3D printer). I was pleasantly surprised by how well a shampoo bar could work, but the bar I'm using has activated Charcoal in it which tends to leave a mess as it drips. So I made this little dish to hold it and keep the drips off the shower while keeping it out of water.The bar I designed this around is “Professor Edward J Fuzzworthy's Gentlemans Activated Charcoal & Beer Hair Shampoo Bar” so any similar sized bar should work for this tray (or anything with a 60mm square face).AssemblyAs you can see there are two parts to this print. The dish and the insert. The insert is intended to snap into the groove on the inside of the dish. This will take some force, but once it's found it's home, it should stay put.