Shad Fishing Lure

cults3d

These are my take on a shad minnow fishing lure. These are about 2.75" long and there are two versions. (solid one piece body and a two piece jointed body) These lures are printed in halves (two or four pieces) and are glue together after printing. (much like most of my lures) They are a little harder to assemble than my other top water lure because there are more pieces and parts. See https://www.theneverendingprojectslist.com/fishingprojects/shad-lures/ for more info. Hardware Required to Assemble Alignment Pins (made from 1.75mm filament) #6 Figure 8 Hook Hangers (Available from Worth Company .177" BB;s for weights 3/16" Eyes I used #6 Treble Hooks w/ #3 Split Rings Tools Required to Assemble Razor Blade/Knife Drill and Bits (1.8mm or a 5/32") Lighter CA Glue (superglue) CA Accelerator Sand Paper Paint Epoxy (to seal everything up) NOTICE - My files and designs are all Copyrighted © and are exclusively for private and personal use. Even if you purchased these files that Copyright means you are NOT allowed to sell the model or any derivative of the model for economic or financial gain. For example, you cannot sell the digital model, a derivative or adaptation of that model, nor can you sell prints of the model. These are for personal use only.