SEVERUS SNAPE WAND - HARRY POTTER

cults3d

"You think you're clever using my own spells against me, Potter? It was I who conjured them up - the Half-Blood Prince himself! And you'd turn my masterpieces back on me like your dirty old father, would you? No way... not on my watch. Behold, my Severus Snape Wand design, inspired by none other than Harry Potter himself! This model was crafted with care and attention to detail in just 2 hours flat. **No Support Required! Just Print and Go!** This wand is cleverly designed as a two-part masterpiece that requires only a dash of glue to assemble. With a layer height of 100 microns (0.1mm), you won't need to break out the sandpaper - what a relief! **Optimal Printing Settings for Your CR-10:** * Layer Height: 100 microns (0.1mm) * Infill Percentage: 70% * No Support Required * Bed Heat: 60 degrees Celsius * Nozzle Temperature: 200 degrees Celsius Get ready to watch this beauty print in just 6 hours flat! I hope you're loving it, guys! Don't forget to follow me on Instagram at @tolgaaxu and @buyucusokagi. If you have any questions or need help with my designs, just shoot me a message - I'm always here to assist. Until next time, stay creative!"