Session mount for Hyperlow Vert racer

thingiverse

This GoPro bracket is designed as either a front or rear loader with precision-cut holes for every interface (buttons, SD card slot, screen), and its most crucial feature is that it hides props from view when shooting in wide-angle mode (25° tilt). However, all props are fully visible in super-wide shots. You won't need to use batteries for the toilet tank as my GNB-S fits snugly behind it, measuring 72mm in length. All 5-inch props clear this mount with about 5mm of space to spare. To assemble this bracket, you'll require two M3x30mm screws for the back and two M3x10mm screws for the front. For optimal results, use thin but long 3mm diameter spacers under the back screws (pressed into the TPU) to avoid compressing screw holes while maintaining the front arm's stiffness. I used a 3mm brass tube cut down to size in my setup. To complete the assembly, you'll still need two M3x30mm screws for the back and two M3x10mm screws for the front.