Servo mount for auto bed-leveling z-probe

thingiverse

This design is based on Servo mount for auto bed-leveling for Prusa i2 X-Carriage. I changed the following: Parametrized the SCAD source. Tweak it to make it fit your servo, X-carriage and hotend exactly. This servo mount can be printed longer or shorter, matching your hotend. The original is too short for E3D v5 hotend. Servo mounting holes are smaller, to match the smaller holes in most micro servos. This mount will fit most X-carriages with 10x10x15mm accessory mounting block. In particular, I'm using Reinforced Prusa X Carriage with Slim LM8UU Holder. The micro servo I'm using is TowerPro SG90, but SCAD file can be adjusted to fit other servos with slightly different dimensions. Instructions Open SCAD file and tweak the settings there as needed. Most important value is the distance between X-carriage's top to the bed, when your hot end is touching it. Print the mount. You'll also need to print the microswitch holder. Follow your firmware instructions to set up automatic bed leveling.