Servo holder for 9g and 3.7g

thingiverse

Part of another project I'm working on that could be useful for others. The servo holder "lite" parts are designed to hold small 9g servos, usually blue and inexpensive. To fit them, cut a 36x36mm square out of the wing material, glue the servo to the plate, and then attach the plate to the wing. The cover plate is there in case you need to cut all the way through for a nice flat finish. The height of the section it fits into can be set below where the wire comes out so it can be routed anywhere. When printed solid, it weighs about 3g. The 3.7g one is a generic design I came up with since I don't have one to measure. It's meant for the 9g but thought someone might need it. For the 3.7g just notch the sides so the lugs of the servo can fit in. These are designed for one side only, the slot is offset so you will need to "mirror" it in your slicer to make a set. There are covers available so you can perforate a wing and seal the other side. The 9g has a spacer in case you have a thin wing that needs lowering. Just use your slicer's Z-axis resize feature to adjust the thickness.