Servbot - Action model kit

cults3d

There are a total of 41 Servbots in the series, and now you can print every single one and amass an army! In this kit is a variety of accessory pieces(10) and heads(12) to give each one you make a little personality! The model kit itself has a decent range of motion and poseability for such a small character. A 3mm hole on it's back enables you to attach a base and pose as you please. Things to have for post-processing *Hobby nippers and knife *Super glue or liquid electrical tape (for joint tightening) *Paint *Sandpaper All things considered it would be easy to say it would take 1 day to fully make one of these little fellows. Notes *Leg joint 1 and 2 have a 1/16mm hole in the middle of the joint. Sliding into it a 1/16mm aluminum rod greatly increases it's stability. *Each head has two faces. I thought this would be the most efficient way to produce them. Imagine the mountain of heads you would printed otherwise! *Building is very straightforward and is typical just snap-to-fit. *Minimal post-processing and painting are required for best results. Small parts require more attention than larger parts. *Tolerances have been checked to about 0.02mm, but please mind that your print settings and filament brand can slightly change those tolerances Please enjoy! And if you have any questions, concerns or comments, feel free to reach out via Cults3D, Twitter, or Instagram! -Velvettoolbox