Sequoia III Table Leg Wrench/Spanner

thingiverse

The ITC Sequoia III table leg system works well for use in boats, campervans, motorhomes and RVs. However it can be difficult to tighten or release the black collar at the base.This solves that problem by providing a correctly fitting wrench that sits on the tapered collar and provides a good grip. The handle incorporates a 'spudger' that slides in and easily pops the plastic cap out of the base ready for the leg to fit it.The wrench/spanner is of open design to avoid the need to fit over the top of the leg. To give the required strength for this, you should ensure at least 4 wall loops and 30% infill. It works well in PLA. I printed mine in two colours (top/bottom) so that it is easy to see if it is the correct side up to fit on the tapered collar. A small layer height (0.16mm or so) will help with the spudger sharpness. Printing on a textured PEI sheet will give a nice texture on the top of the wrench/spanner.