Separate Token / Dice and Card Box STLs to suit Necromunda Ash Wastes - Magnet Ready

myminifactory

This is a set of STLs for two 3D printable token/dice and card and boxes to suit Necromunda Ash Wastes and other games with the same dice, card and token size/number. It comes with a card and token scale finder so that you can test print a small section of it to see how the size goes on your particular printer, and adjust if necessary - without wasting a whole print to discover that. The default scaling works for most printers but I have had numerous comments that anything from 97% to 103% works for some people's printer setup, so it's worth checking before printing the whole thing. The test card slot is designed for the Campaign Cards. Keen to hear any feedback - happy to adjust the design if required. Suits 5x1mm magnets, takes four at most (two on the lid, two on the base). Helps keep the lid in place but still don't tip it upside down unless you like a mess. The card box is: Base - 8.52cm wide, 12.6cm long, 8.04cm tall, Lid - 8.52cm wide, 12.6cm long, 2.5cm tall. The token/dice box is: Base - 9.17cm wide, 14.8cm long, 3.62cm tall, Lid - 9.17cm wide, 14.8cm long, 4.04cm tall.