Sentinel Wreck Flyer Base Objective

thingiverse

I'm using these for flyer bases, and they can also serve as objective markers, wrecked vehicle markers or cover for miniatures. Two versions are available: a closed top and an open top model with a blasted surface. The open top has just enough room for a single model to fit inside the opening; supports will be needed for this version. The closed top model prints with minimal support structures, but results may vary depending on your printer settings. I've also included versions that don't include the complete flyer base; the first .5mm layer should print fine assuming your bed level and calibrations are correct. My initial test print using old lime-green PLA on the Afinia worked out well - I've attached an image.