SEMTO FS-L200AC Experimental Mounting Bits and Bobs

thingiverse

This thing is a collection of a few experimental (I’m still trying to get the engine running properly myself – so please note these bits have not been tested for a long run yet) bits and bobs I printed to use with SEMTO FS-L200AC model engine. There are 3 images included showing what each STL is. For the Hall Screw Mount (part 3 of 3) please note in the image you will see I have cut this in half as I ran out of adjustment so I’m currently only using one screw. I have yet to design a mount that gives me enough adjustment with 2 screws. The small and large mounts may need a bit of rubber or similar under them to make them tight enough. I have printed it out of PLA, the main engine mount has some short pieces of fuel tubing separating the engine from the PLA. I have not been able to make the engine run for long enough yet to know if the PLA will get too hot and melt – so something to watch out for if you give it a go!