Semi Circular Anycubic 4Max Fan Duct

thingiverse

This is a remix from popular Semi-Circular Anet A8 Fan Duct made by lokster.\r\nI just added mounting brackets and took precise measurements, making sure everything fits perfectly. I didn't alter the blower part except for the top mount.\r\n\r\nPrint it exactly as shown on my build plate, and avoid printing supports within the blowers themselves. For reference, check out my Cura settings screenshot. Double-check your supports before starting the print.\r\n\r\nI also added three extra holes to the bracket for zipping cables in place. I find it annoying when cables hang loose from the Bowden tube. Refer to the pictures for a better understanding.\r\nMake sure that nozzle heater wires (Power and Probe) are not pushing down on the blower. Zip tie the wires higher up, or they will push the blower downwards, causing deformation at its backside.\r\n\r\nPRINT TIP: Try printing in ABS if possible. After a large surface print, PLA ducts tend to deform due to heat from the bed and nozzle block. I might attempt to add an extra mounting point if I can find a suitable location.