Self-draining Succulent Planter

prusaprinters

No supports required!Designed to minimize filament use, while maintaining strength!Entire print fits inside a single Prusa MK3 bed!All perimeters are sized to perfectly print with two perimeters with zero infill! (except the base frame)Frame sits on counter4x Pot holder sits on frameat a 4.7 degree anglewith standoffs, so water can run off easily under the potswith spout on the “low” end, for water to drain out into a sink or receptacle.60mm Pots sit in the pot holdertop of pots cut at same 4.7 degree angle, so they appear terraced.pots have a tonne of drainage, no matter their orientation - but not too much that soil drops out!The end result is when you water your succulents, the water magically drains into the sink.