Self-Draining Soap Dish (SKYRIM-THEMED!)

thingiverse

Someone requested a self-draining soap dish so that the dish doesn't contain water or get gross. I said sure and made it Skyrim-themed behind his back after he refused the Skeletor one. The dish has a spout hidden in the dragon's mouth and the bed of the dish is at a slight tilt (I think it was 15 degrees). I printed this at the "low resolution" setting on the Creator Pro and used supports. If you plan on using supports, be prepared to clean out the mouth very well because soap may build up over time. I printed this with a raft and I would recommend doing that because it helps to take the supports off. I did not create the Skyrim logo or the dragon skull. I just found them on Thingiverse (hence the remix). If any of it looks messy, just keep in mind that I spent only 15 minutes clearing out the supports and raft. The scale of this thing is whopped up (it's all uniform, don't worry). I printed mine at about 160% of the original model, and if it was slightly bigger, it would hold the soap well. When I printed this, it wanted to "repair the model." For me, it just got stuck on 60% done, so I went ahead and printed it. Despite this, it came out fine.