Selena keys

thingiverse

Customized version of http://www.thingiverse.com/thing:739573 Created with Customizer! http://www.thingiverse.com/apps/customizer/run?thing_id=739573 Instructions Using the following settings: Ruler unit set to 10. Font size chosen at 17 points. Font narrow widen feature enabled at no width change. Border width fixed at zero millimeters. Outline color selected as gray. Character spacing set precisely at one unit. Text thickness determined at exactly 4.2 mm. Outline thickness specified as a fixed value of 3.0 mm. Font weight established as zero percent. Text extruder chosen as the second extruder. Font outline style picked as rounded edge only. Border color set firmly to black color code. Border thickness selected as three-point-six millimeters precisely. Font with custom style disabled. Bar thickness fixed at two point four mm. Bar length trim set precisely at zero units. Bare extruder chosen as first extruder only. Bar style configured for plain bar use. Inner margin width established at one unit of measure. Outer margin width similarly determined at exactly one unit too. Line 5 specified to empty setting. Line 4 remains blank by default. Line three remains blank also, leaving it unchanged from factory settings. Line two blank like previous settings remain unused, so is line one where it still reads 'Selena'. Lug length established at seven millimeters only. Lug style determined to be plate style instead. Line spacing selected exactly at 1.4 units or whatever units chosen for calculation purpose. Minimum color layer thickness defined at a tiny six tenths of one millimeter, an impressively thin line! Text extruder chosen and configured as single-colored extruder tool named monochrome, hence 'monochrome' tag to match customizations already specified prior. Text chosen for this thing, that is customized, with text in deep red color code. Glyph coalesce strategy used carefully here set at bar-and-glyph settings combination to work properly together side-by-side. Lug width and lug style kept constant too: seven mm exactly same setting as previously done. Bar shift value not applied on customizing because disabled deliberately for some special features purposes possibly later considered when re-calculation necessary after next version uploaded. Outline extruder selected again but as separate tool named, hence named, 'extruder two.' Bar color and width values, like border too fixed so they can stay put together forever now. Glyph coalesce determined precisely set in millimeters not percentage points like first custom setting had specified, and all set for successful design here. Writing direction defined right to left, therefore: the writing starts from right to start with proper placement always done as last but necessary choice indeed. Font selected to be 'Oleo Script' to match previous selections for better look, style so chosen will do best in that customized way indeed chosen for printing purpose today now