Secure Latch

prusaprinters

<p>This latch won't budge until you pull up on the lever - just what you need for an RV or boat where shifting contents can cause a normal latch to spring open. And it has an integral printed spring that makes it snap shut with a satisfying click. It is designed for flush 12mm door panels and latches directly onto a 1" thick face frame. (I've included the design files so you can customize for other panel and face frame thicknesses.) It works with both doors and drawers.</p> <p>I've also included the file for printing your own hinges!</p> <h3>Print Settings</h3> <p><strong>Printer Brand:</strong></p> <p>MakerGear</p> <p class="detail-setting printer"><strong>Printer: </strong> <div><p>M2</p></div> <p><strong>Rafts:</strong></p> <p>No</p> <p class="detail-setting supports"><strong>Supports: </strong> <div><p>Yes</p></div> <p><strong>Resolution:</strong></p> <p>0.2mm</p> <p class="detail-setting infill"><strong>Infill: </strong> <div><p>35%</p></div> <h3>Post-Printing</h3> <p>The latch uses a 1 1/8" long #6 screw for the pivot. You'll need to cut a notch in your panel 1.025" wide by 0.850" deep to hold the latch. You can secure the latch in place with two 18 gauge brads.</p> <p>The hinge halves are identical - print two per hinge. Use a 1 1/2" long 4D finish nail for the hinge pin. If the nail hole is too tight, you may want to drill it the hole out with a 5/64ths drill. Mount the hinges with #6 screws.</p> </p></p></p> Category: Replacement Parts