SecKit SK-GO Filament Sensor Mount

thingiverse

This is a mounting solution for the filament sensor of the SK-GO. It's specifically designed for implementing a reverse Bowden setup. This design utilizes the BMG Bowden mount provided with the kit, which you can disregard if you're opting for direct drive instead. This assembly enables a standard reverse Bowden configuration. To create this setup, I employed the use of supports. However, it remains uncertain whether they are truly necessary. You will need to gather the following components: 2 M3x16 bolts (M3x14 would be an even better choice, but I opted for 16 with a nut as a spacer) 4 M3 nuts (two for securing the spacer on the M3x16 bolt) 2 M3x8 bolts 2 M3 T-nuts The rear-mounted nuts were a bit of a tight fit, so I resorted to using pliers to press them into place.